I purchased a VXDIAG VCX Nano for Ford and Mazda vehicles back in 2019, I must say that I was skeptical of the product but decided to give it a try.
After a week of use I was very impressed. I found the vx nano can be used as a J2534 Pass-Thru device.
It does get recognized by the OEM J2534 software so i am going to show you two programs that i used one for Nissan and one for Kia.
I have plugged it over here and it is plugged into the usb.
We’ll go over to Nissan (Nissan J2534 ECU Reprogramming Software)
i also have the FJDS bt that one you need a license.
with the Nissan we can actually get through it.
when you download the vx manager basically it shows up as a j2534
We select VXDIAG device
we will go next and then it read it as a j2534 passthru device as you see right here supplier allscanner
We don’t have a Nissan to test. But the vcx nano ford device can be recognized by the Nissan program.
We also tested it on Kia program
Run J2534 KMA program
the program require to enable network connection
check the power switch and cable connection of the passthru device
select VXDIAG-J2534
initialization of passthru device
We do have a Kia car for test.
No comments:
Post a Comment