The new vxdiag vcx se for Benz device is designed to diagnose and program Mercedes benz cars. You can also use BMW and a lot of all sorts of programs that it supports. Here we show how it works in VCI mode, like VXDIAG Benz C6.
The device is good workmanship, good usb cable and plastic case.
The software supports Mercedes 20105 up, it does not support older models. This is the drawback. But everthything seems to be set up now.
We are testing this device. We will show the installation and configuration of Passthru also OpenShell XDOS.
Vxdiagshop provides HDD or SSD Openshell version. You can make it work with Passthru if you wish.
We will also demonstrate its operation.
The vcx se Benz device also has the ability to support DOIP for updating commands and newer cars.
First of all, we need to download vx manager driver on VXdiagshop.com
They have latest version vxdiag related driver and software available.
The device has the ability to work via wifi and also through USB cable.
We start install vx manager driver
Install Passthru J2534 and BENZ XENTRY program
Other license are listed here. You need to buy a license for them separately.
Finish install VX Manager
The device is now connected via a USB cable.
Check device information, serial number
Go to Diagnostic tab
Choose Passthru, run an update
Driver is being installed, updated.
Update C6 driver as well
Complete installation, we see the voltage, which is shown below and the internet is also connected to it.
In this case ,vcx se will not connect in VCI mode, because we first test the Passthru program, not OpenShell.
Connect vcx se Benz with vehicle (ML-164) via OBD socket
We connect without cable via wifi
Connect via a WIFI connection, in fact a vey convenient device, with higher capabilities, works more fully with Passthru than Openshell.
Open vx manager, we see that we have WIFI connection, see the tabs in which you can reboot it, connect DoIP, update the firmware.
We launch xnery and select VXDIAG using the passthru j2534 protocol.
All the rest work is the same as through Openshell, you must use the ‘ignition enable’ file which replaced the ignition emulator, connect to our car, we see that we have ignition file.
We run a short test.
It works quite quickly, it main advantage is that you can remotely connect to this device through the cloud (DONET remote diagnosis), even while at home.
All modules are read correctly, and old car is in DAS to check how it works.
We see that we forgot to start the ignition file, the ignition emulator, now we have it active.
The program correctly see the ignition lock.
For the price and function, it is worth buying.
https://www.vxdiagshop.com/service/vxdiag-vcx-se-benz-doip-unboxing-and-review.html
No comments:
Post a Comment